Tutorial: Introduction to the Arduino

--D. Thiebaut 15:18, 20 April 2011 (EDT)

---

The Reference Pages

• | The Arduino Language Reference
• | The Getting Started guide

Good Tutorials on the Web

• Arduino Tutorial at UCLA

Notes for Mac Users

• You may have to install special drivers for your Mac to see the Arduino through the USB Port. Look here for more info: http://www.ftdichip.com/Drivers/VCP.htm

An Introduction to C in the Arduino Context

Comments

// this is a comment
/* and so is this */
/* and
    this 
    as 
    well */

Setup() and Loop()

• Setup()
• Loop()

Output

Output strings from the Arduino to Laptop

• Done with the Serial library
• Use Serial.begin() to set the baud rate (# of bits per second)
• Then output strings with Serial.println( ... ) or Serial.print( ... )

void setup() {                
 Serial.begin( 38400 );
 Serial.println( "Hello there!" );
}

void loop() {
 delay(1000);              // wait for a second
 Serial.println( "hello again!" );
}

Output numbers

• Taken from http://arduino.cc/en/Serial/Print
  • Serial.print(78) gives "78"
  • Serial.print(1.23456) gives "1.23"
  • Serial.print(byte(78)) gives "N" (whose ASCII value is 78)
  • Serial.print('N') gives "N"
  • Serial.print("Hello world.") gives "Hello world."

An optional second parameter specifies the base (format) to use; permitted values are BYTE, BIN (binary, or base 2), OCT (octal, or base 8), DEC (decimal, or base 10), HEX (hexadecimal, or base 16). For floating point numbers, this parameter specifies the number of decimal places to use. For example:

• • Serial.print(78, BYTE) gives "N"
  • Serial.print(78, BIN) gives "1001110"
  • Serial.print(78, OCT) gives "116"
  • Serial.print(78, DEC) gives "78"
  • Serial.print(78, HEX) gives "4E"
  • Serial.println(1.23456, 0) gives "1"
  • Serial.println(1.23456, 2) gives "1.23"
  • Serial.println(1.23456, 4) gives "1.2346"

Inputting characters

• Use Serial.read() and Serial.available(), as illustrated below

void setup() {                
  Serial.begin( 38400 );
  Serial.println( "Enter one characterA in the console and send it: " );
}

void loop() {
  int charByte;
  
  if ( Serial.available() > 0 ) {
    charByte = Serial.read();
    Serial.print( charByte, DEC );
    Serial.print( " is " );
    Serial.print( charByte, HEX );
    Serial.print( " in hex.\n\n\n" );
    Serial.println( "Enter another character in the console and send it: " );
  }
}